[C320-list] Stanchions

[Bryan Campbell]

There are three (3) bolts for each single stanchion.

-----Original Message-----
From: C320-List-bounces at catalina320.com
[mailto:C320-List-bounces at catalina320.com]On Behalf Of pat reynolds
Sent: Saturday, July 15, 2006 10:00 AM
To: John Van Vessem; C320-List
Subject: Re: [C320-list] Stanchions


there is also a large bolt, washer and nut on the
bottom of the stanchion where it goes thru the toe
rail.  On hull 249 the wood trim piece is attached to
a fiberglass lip.  My stubby fingers couldn't get up
under this to get at the nut so I used a circular
drill bit to open a hole in the lip.  If you are lucky
the bolt and nut won't be partially buried in the
hull-deck sealer.  If it is you can just chip around
it.

Pat R. 

--- John Van Vessem <jvanvessem at sbcglobal.net> wrote:

> To All,
>  
> I will have to remove one of my stanchions because I
> think it is the culprit that is causing a leak in
> the cabin.  I question how the stanchion is attached
> to the deck and gunwale.  I can believe that it is
> only the two screws in the deck plate that hold the
> stanchion rigid.  Is there something that goes up
> inside the stanchion?
>  
> John Van Vessem
> Sojourn 645
> Vallejo Yacht Club 
> 
> 
>  
> 


__________________________________________________
Do You Yahoo!?
Tired of spam?  Yahoo! Mail has the best spam protection around 
http://mail.yahoo.com 

---
[This E-mail was scanned for viruses by Declude/F-Prot Virus]




---
[This E-mail was scanned for viruses by Declude/F-Prot Virus]