[C320-list] Water lines

[alahlm at comcast.net]

Morey
I don't think you need to remove the grey c clip --on mine you just push the collar in and pull the 15mm pipe out --- the protective collar that spins around does need to be slid back--see www.whale-usa.com
-------------- Original message -------------- 
From: David J Gleason <djgleason1 at juno.com> 

> Morey: 
> 
> To remove the line from a fitting it is very simple: 
> 
> 1 - Remove the plastic cap from the end of the fitting where the water 
> line enters. A small flat blade screwdriver works best. 
> 
> 2 - Remove the grey plastic C clip that is set into the fitting just 
> below where the line enters the fitting. 
> 
> 3 - Press down on the ring that the C clip was keeping in an extended 
> position. 
> 
> 4 - Pull the line out of the fitting. 
> 
> To reinstall, reverse the above steps. 
> 
> Dave Gleason 
> Proud Mary, #150 
> 
> On Fri, 27 Oct 2006 20:35:30 -0400 "Morey Waltuck" 
> writes: 
> > Our C320 was built in 1996 and has the Red and Blue piping system. 
> > To 
> > remove a water line from a fitting, do we somehow remove the end of 
> > the 
> > fitting which seems to rotate fairly freely? 
> > 
> > Morey Waltuck 
> > Getaway #352 
> > 
> > 
> > 
> > 
> > 
>