[C320-list] Macerator

[Kirk McCullough]

I installed a push button at the pump, which is enable by the rocker switch 
on the panel, but you must be at the pump with your thumb on the spring 
loaded button to pump out into the sea.

Kirk

#124
----- Original Message ----- 
From: "Joe Barrett" <joe at dolphinmortgage.com>
To: <C320-List at Catalina320.com>
Sent: Monday, June 16, 2008 7:49 AM
Subject: Re: [C320-list] Macerator


> My local West Marine had the Impeller. It didn't say it was for a 
> Macerator
> but I matched it up against the old one and the diameters were exact. It
> said it was for water or oil pumps and it fit fine. Came with Impeller
> Lubricant that I also used to Lube the inside of the hoses and the outside
> of the hose fittings to make it easier to get the hoses off in the future.
> The same thing happened to me, a fairly blind crew member who wears 3
> different sets of eye glasses depending on his eye needs thought he was
> putting the water pressure switch on and instead put the Macerator with a
> brand new impeller installed just two weeks earlier. With the noise from 
> the
> engine and the stereo going I didn't notice it until 4 hours later when I
> went down below and saw the macerator switch on. It was much easier to
> replace the impeller once the 3 hoses are disconnected from the pump.
> Joe
>
>
> ------------------------------------
> Worldbanc Financial Group of Naples
> Joseph T. Barrett jr.
> Branch President
> jb at worldbancfinanceulp.com
> 9010 Strada Stell Court
> Suite 209
> Naples, Florida 34109
>
> In The Vanderbilt Galleria
> tel: 239-597-2266
> tel2:877-437-2262
> fax: 239-597-7276
> mobile: 239-777-1880
> www.worldbancfinanceulp.com
> ------------------------------------
>
> -----Original Message-----
> From: c320-list-bounces at lists.catalina320.com
> [mailto:c320-list-bounces at lists.catalina320.com] On Behalf Of Jon Vez
> Sent: Monday, June 16, 2008 10:34 AM
> To: C320-List at Catalina320.com
> Subject: Re: [C320-list] Macerator
>
> Darrell,
>
> I also have a Jabsco and had to do this job the first year I had the boat.
> Someone accidently hit the macerator switch instead of the water pressure.
> My old boat had a spring loaded switch to prevent this. I did the job at 
> the
> boat and it wasn't bad at all. Take Pat's advice and fill the tank with
> water and a little bleach and have it pumped. If the pump out guys aren't
> busy and sympathetic ask them if they will wait for you to fill it with
> water a second time and pump it out again. Just stuff some rags in the 
> hoses
> and cover with baggies while you work on the pump--it's easy to take apart
> and Jabsco has the schematics on their web site if you don't have your
> manual anymore. Once you get the pump off the job takes about 10
> minutes--Good luck...
>
> Regards,
>
> Jon Vez
> Solstice #582
>
> -----Original Message-----
> From: c320-list-bounces at lists.catalina320.com
> [mailto:c320-list-bounces at lists.catalina320.com] On Behalf Of Darrell
> Sent: Monday, June 16, 2008 9:28 AM
> To: C320-List at Catalina320.com
> Subject: Re: [C320-list] Macerator
>
> Hi John,
>
> The shaft is turning, sounds like the impeller blades. I believe it is a
> jabsco but I could be wrong. Not sure if I save more time taking the unit
> apart on the boat or just removing the whole thing and taking it home. I
> will try and find my receipt and see if is still under warranty,
>
> Darrell
>
>
> ----- Original Message -----
> From: "Jon Vez" <jonvez at comcast.net>
> To: <C320-List at Catalina320.com>
> Sent: Monday, June 16, 2008 5:45 AM
> Subject: Re: [C320-list] Macerator
>
>
>> Darrell,
>>
>> Did you try to manually turn the shaft with a screw driver? If not, try
>> that
>> first. At the end of the pump you should find a rubber cap. Remove that
>> and
>> take a flat head screw driver and turn the shaft a few times then try the
>> pump. If that does not work, you more than likely have lost the impeller
>> blades. You can change out the impeller without replacing the pump. You
>> said
>> you replaced the pump last year, so if it is not the impeller you should
>> be
>> able to get a warranty replacement. Do you have a shurflo macerator?
>>
>> Good luck,
>>
>> Jon Vez
>> Solstice #582
>>
>>
>> -----Original Message-----
>> From: c320-list-bounces at lists.catalina320.com
>> [mailto:c320-list-bounces at lists.catalina320.com] On Behalf Of Darrell
>> Sent: Monday, June 16, 2008 8:34 AM
>> To: C320-List at Catalina320.com
>> Subject: [C320-list] Macerator
>>
>> When I was macerating last weekend. I noticed the pump was running very
>> quietly and that the holding tank did not completely empty no matter how
>> log
>>
>> I pumped. IT sounds like the pump motor is turning but the pump apparatus
>> at
>>
>> the end is not. Does this sound reasonable. The unit was just replaced
>> last
>> year. should I replace the whole pump assembly or just the end that
>> appears
>> not to be working. It looks like they can be separated. Any advice would
>> be
>> appreciated,
>>
>> Darrell
>>
>> Antares, #88
>>
>
>
>
>
> -- 
> No virus found in this incoming message.
> Checked by AVG.
> Version: 7.5.524 / Virus Database: 270.4.1/1513 - Release Date: 6/22/2008 
> 7:52 AM
>
>