[C320-list] New Engine Mounts
brer at adelphia.net
brer at adelphia.net
Sun May 25 20:41:32 PDT 2008
Sounds like a great fix. How many hours are on your Perkins?
Don
---- "Chris Block ..._/)...._/}..." <chris_block at comcast.net> wrote:
=============
did you do the change? where did you buy the parts? how much for the
parts? labor?
Chris
Amore #139
----- Original Message -----
From: "Mike Shoffner" <drshoffner at yahoo.com>
To: <c320-list at lists.catalina320.com>
Sent: Sunday, May 25, 2008 8:08 PM
Subject: [C320-list] New Engine Mounts
Over the years there have been threads devoted to the vibrations at low
RPM's of the older boats with Perkins engines. I've noted this with my boat
ever since I boughtit 4 years ago, and I've just attributed it to being a
characteristic of the Perkins engine. Recently, because of my cutless
bearing wearing out in one season of use, I had my shaft allignment checked
and was advised I needed new engine mounts. What a difference!! The old
"Perkins vibrations" apparently were due to worn engine mounts' and with new
mounts there are zero vibrations at low RPM's. At higher RPM's engine noise
and vibrations are also noticably reduced as well. Mine is a '94 model and
probably needed new mounts for several years. I would advise owhners of more
mature boats to consider having their engine mounts replaced if they're
having problems similar to mine.
Regards,
Mike
#171
More information about the C320-list
mailing list