[C320-list] Fresh water connectors
BAdams3491 at aol.com
BAdams3491 at aol.com
Mon Aug 10 17:18:20 PDT 2009
The sensors come apart by carefully prying the two halves apart...there
are two slots (opposite each other) where the small screw driver goes. After
apart, there is a horseshoe shaped washer that fits between the locking
collar and the end of the fitting called a Collet clip...it pops out by using
a small screw driver. The Collet clip is on page 101 of the 2009 Defender
catalog. Here's the web site:
_http://www.defender.com/productsearchresult.jsp_ (http://www.defender.com/productsearchresult.jsp)
Bert
At Ease
#442
In a message dated 8/10/2009 7:09:35 P.M. Central Daylight Time,
mparis495 at gmail.com writes:
How do you remove the connectors on the blue and red plastic pipes for
the fresh water system? My previous owner used a 2" piece of copper
pipe in place of the blue pipe between the faucet T and the water
heater. This fitting drips.
Thanks,
Mike P
734
Sent from my iPhone
More information about the C320-list
mailing list