[C320-list] Small leak at Propeller Plate

[Peter & Barbara Sheerin]

Paul, I had the same problem on my hull# 1096. Close inspection revealed a 
breakdown in the sealant around the support base. You will have to make sure 
that all the water is removed from the cavity prior to re sealing. Ours held 
about half a litre! Check the Catalina website out for the recommended 
repair. Quite good. I think the problem arises from the vibrations generated 
by the prop shaft, especially going from forward to reverse. You have to 
make it a habit of checking it periodically. Good luck.
----- Original Message ----- 
From: "Paul Adison" <pjaarch at verizon.net>
To: <C320-List at Catalina320.com>
Sent: Monday, November 09, 2009 11:05 PM
Subject: Re: [C320-list] Small leak at Propeller Plate


I too just noticed this problem yesterday as I was pulling the
propeller.  I am considering a little marine tex and barrier coat for
the fix.

On Nov 8, 2009, at 10:35 PM, annika brancato wrote:

>
>
> Hi
>
> We have noticed small trickle of water at the seam of the plate that 
> holds the propeller shaft.  Has anyone else had this problem.
>
> There is a slight movement at the seam and droplets of water has 
> appeared.
>
> Anyone has any advice as to how to proceed.  Members of our club  told us 
> to drill small shallow wholes to allow any water to drain  and then seal 
> up seam properly.
>
> Any help or suggestions are appreciated.
>
> Annika &  Dino
> Snapshot 95
>    _________________________________________________________________
> Windows Live: Gör det enklare för dina vänner att se vad du håller  på med 
> på Facebook.
> http://www.microsoft.com/sverige/windows/windowslive/see-it-in-action/social-network-basics.aspx?ocid=PID23461::T:WLMTAGL:ON:WL:sv-se:SI_SB_1:092010