[C320-list] Pedestal Guard

[alahlm at comcast.net]

Becky 



     the job was pretty easy    I bought a kit that had the guard, new feet, and the mounting plate   removing the old nav pod was easy just make note of what wire goes were, the compass lifts right off, pull out all the wire from below, remove the guard then the feet, put in new feet then drill down thru feet ( i think i used a 3/4" drill in both feet ) replace plate and guard  and add new nav pod and pull wires back up 



   Good Luck    Al Ahlman 

                            #476 



   PS if you still have  ? call my cell  603-493-5925 



     
----- Original Message -----,   
From: sail320 at hotmail.com 
To: C320-List at Catalina320.com 
Sent: Tuesday, April 27, 2010 11:55:03 AM GMT -05:00 US/Canada Eastern 
Subject: Re: [C320-list] Pedestal Guard 

Thanks. How did you increase the size of the holes in the sole of the boat? 

alahlm at comcast.net wrote: 

> 
> 
>Becky 
> 
>   I replaced mine with a 1.25" offset pedestal guard last year with no trouble 
> 
> 
> 
>Al Ahlman 
> 
>  #476 
>----- Original Message ----- 
>From: "Becky DeVillier" <sail320 at hotmail.com> 
>To: c320-list at lists.catalina320.com 
>Sent: Friday, April 23, 2010 9:56:24 AM GMT -05:00 US/Canada Eastern 
>Subject: [C320-list] Pedestal Guard 
> 
> 
>Has anyone replaced the pedestal guard on an older 320? I am considering upgrading to a 1.25" guard to more easily allow the installation of radar.  Any information would be appreciated. 
> 
>  
> 
>Becky 
> 
>Synergy #201 
>                                                
>_________________________________________________________________ 
>The New Busy is not the too busy. Combine all your e-mail accounts with Hotmail. 
>http://www.windowslive.com/campaign/thenewbusy?tile=multiaccount&ocid=PID28326::T:WLMTAGL:ON:WL:en-US:WM_HMP:042010_4 
>