[C320-list] Pulling Wires

[Barbara Uhlman]

Alan,
Several years ago, on another boat, we needed to run wire from cockpit to nav 
station.  To run along the bottom of the boat, we first fed a steel tape 
measure, taped the wire to the end of the steel tape measure and pulled it back 
out through.  In this instance, it worked great.

Barb
Whisper, #1158



----- Original Message ----
From: "Albrecht, Alan" <Alan.Albrecht at Williams.com>
To: "C320-List at Catalina320.com" <C320-List at Catalina320.com>
Sent: Tue, December 7, 2010 8:27:25 AM
Subject: [C320-list] Pulling Wires

I am getting ready to install a Standard Horizon GX2100 AIS/DSC radio. I will 
most likely need to pull at least 3 wires between the VHF Radio at the main 
saloon Nav Station and the GPS Station at my Binnacle. In addition I am 
installation a RAM Mic near the wheel. Does anyone have any advice before I 
start researching how to run the wires between the two components and route the 
RAM Mic cable to the transom?

Alan Albrecht, PE
Williams Deep Water Group
Houston
Cell 918-625-7352