[C320-list] LinkPro problems

[Mike Paris]

I have two flooded 4Ds, a Xantrex Truecharge2, and a LinkPro battery monitor. I am plugged into AC shorepower when in my slip. 

When I return to the boat after it has been on the charger a couple of days, the LinkPro shows a low battery message. The voltage on each battery reads 13.4 on the LinkPro, a multi-meter, and the Catalina stock gauge. The charger shows that it is charging. 

This morning I did a test. The main battery was down to 80% on the LinkPro (I went out yesterday but did not plug in the charger).  I then ran the charger for 3 hours. The LinkPro and the charger indicated a charge was taking place for 3 hours. However, the charger then changed to float mode and the charging stopped. The Linkpro still showed only 89.3% charge on the main battery. Both batteries indicated 13.4v at this point as well. 

It seems that the charger and the Linkpro are not in sync. I've been doing manual synchronization when I get the low battery message. I'm guessing that my setting are wrong somewhere. 

Thanks for any and all advice. 

Mike P
#734


Sent from my iPhone