[C320-list] Bow hatch measurements

[Brad Kuether]

Mine is actually a Lewmar, and the seal around the glass failed.

There is an outfit in CT that specializes in the replacment and even the 
Lewmar folk recommend them.

http://www.selectplastics.com/

You take the entire cover off, and send it, and he sends it back all 
re-sealed and fixed, much less the cost of a new one.

I need the dimentions to make a wooden cover to stay in place while the 
hatch cover is out being repaired.

-Brad, Mary, Monica, and Jarod
"Independence"
2004 Catalina 320 Hull 1006
Middle River, MD

----- Original Message ----- 
From: "Larry Frank" <WindSwept at stx.rr.com>
To: <C320-List at Catalina320.com>
Sent: Saturday, February 05, 2011 10:23 PM
Subject: Re: [C320-list] Bow hatch measurements


>I am interested in the reason for the replacement or repair.
>
> I have a small crack radiating out from what seems to be stone chip like 
> you
> might have on a car windshield.  I'd like to think I was sailing that fast
> but I think the crew dropping something like the end of the whisker pole 
> is
> more likely.
>
> I was wondering if just the Plexiglas could be replaced?
>
> Does anyone know?
>
> Larry
> S/V WindSwept
> Catalina 320 #246
>
> -----Original Message-----
> From: c320-list-bounces at lists.catalina320.com
> [mailto:c320-list-bounces at lists.catalina320.com] On Behalf Of Brad Kuether
> Sent: Saturday, February 05, 2011 10:20 AM
> To: C320-List at Catalina320.com
> Subject: [C320-list] Bow hatch measurements
>
> I have to replace my bow hatch or at least get it repaired.  I need to
> construct a temporary hatch.
>
> I measured this, wrote it down, and lost the paper......
>
> I think it was 22 inches square,  Does anyone know if this is correct?
>
> Its going to be 40 degrees tomorrow and I want to get this done....
>
> Thanks so much in advance and sorry for being so "un-organized"
>
> -Brad, Mary, Monica, and Jarod
> "Independence"
> 2004 Catalina 320 Hull 1006
> Middle River, MD
>
>