[C320-list] Changing the prop in cold weather

[fred.lecuyer@live.com]

Thanks Allen. Any need to worry about heat deforming the cutlass bearing?

Fred

Sent from my HTC Inspire™ 4G on AT&T

----- Reply message -----
From: "Allan S Field" <allan.field at verizon.net>
To: <C320-List at Catalina320.com>
Subject: [C320-list] Changing the prop in cold weather
Date: Sun, Dec 30, 2012 8:22 am


Fred - More heat should work.  My experience is that it generally will take
a MAP torch to get enough heat on the prop to break it loose.  The MAP
applies about 3 times the heat of a propane torch.  The Association prop
puller tool also would be very helpful and we supply an adjustable crescent
wrench with the tool!  The prop puller is out on loan currently but should
be available soon.  The form for requesting the puller is on the website.  I
obviously can't ship a MAP cylinder however.

Allan S. Field - C320 Toolbox Custodian
Sea Shadow - #808
Columbia, MD

-----Original Message-----
From: c320-list-bounces at lists.catalina320.com
[mailto:c320-list-bounces at lists.catalina320.com] On Behalf Of Fred LEcuyer
Sent: Saturday, December 29, 2012 5:09 PM
To: Catalina320list Catalina320list
Subject: [C320-list] Changing the prop in cold weather

Maybe one of you has done this before and has some words of wisdom.

I've gotten a three blade prop to replace the original two blade and decided
that, as the weather was about 38 degrees F here, today would be a good day
to do a job on the boat ;>)

Here's what I did:
STEP 1.     Sprayed PB Blaster in the area of concern and let it sit for
about 10 minutes. 
STEP 2.     Fiddled with the wrenches that I had and found only the vise
grip was large enough to get around the first nut.
STEP 3.    Heated the first nut with a propane torch for a few minutes.....
not enough to make it glow and Rudolph was on vacation anyway, so no help
there.
STEP 4.   Applied the vise grip on the outer nut and (yes, I admit it) a
pipe wrench on the inner nut.
STEP 5.  Tapped the vise grips with a hammer while holding the pipe wrench
as steady as possible.
STEP 6.   Grimaced. (Did I mention that I had shoulder 12 months ago and now
the other shoulder is jealous?)
STEP 7.   Cursed and told myself I either need better wrenches, more heat or
...... a yet bigger yard bill.


At this point I like to hear from anyone about what size wrenches I need and
any other tips on doing what I thought was going to be a simple job.

Many thanks for your thoughts.

Fred
First Light
Hull 926