[C320-list] Ignition Key Problem

[John Frost]

On my boat the third detent is springloaded off and it turns on my
glowplugs.

Happy Sailing!

John
2007 C320MKII
Hull 1118
Guntersville, AL



-----Original Message-----
From: c320-list-bounces at lists.catalina320.com
[mailto:c320-list-bounces at lists.catalina320.com] On Behalf Of Joseph R
Aberdale
Sent: Monday, May 28, 2012 10:53 AM
To: C320-List at Catalina320.com
Subject: Re: [C320-list] Ignition Key Problem

Why not a 2 stage switch instead of a 3 stage?  On my boat there is a
starter button on the pod that you push to start after turning on the key
two positions. The third position is a spring action starter switch , not
needed.  This third position is like that on a car which you need to start
the engine.

Joe

On May 25, 2012, at 5:30 PM, Simon Rock wrote:

> Do you really need a key? Is the purpose of the key  to prevent the 
> boat being stolen?
> Why not replace it with a waterproof three stage switch.
> 
> On our boat, we always turn the engine power off at the circuit 
> breaker, so anybody climbing aboard cannot start the engine and motor off.
> 
> Just a thought.
> 
> 
> Simon Rock
> Lake Macquarie NSW Australia
> 
> Cat375 #54 Rock The Boat
> Cat375 #41 Rocket
> Cat320 #1163 Rockstar
> 
> Experience The Whitsundays
> www.cya.com.au
> -----Original Message-----
> From: c320-list-bounces at lists.catalina320.com
> [mailto:c320-list-bounces at lists.catalina320.com] On Behalf Of Karl 
> Mielenhausen
> Sent: Saturday, 26 May 2012 5:44 AM
> To: C320-List at catalina320.com
> Subject: Re: [C320-list] Ignition Key Problem
> 
> Why not a little Super glue on the backing nut?
> If you want replacement parts, contact:
>    Dennis Igarashi at Seaward
>    dennisi at seawardproducts.com
>    562-699-7997  ext 210
> 
> 
> On Fri, May 25, 2012 at 3:36 PM, Joseph R Aberdale 
> <summerwind3 at comcast.net>
> wrote:
>> When I attempt to turn my key to start the boat the key housing turns 
>> as
> well and the key does not go to the "on" position. I looked inside the 
> pod and found that the large nut used to tighten the housing cannot be 
> tightened as the threads have been stripped. Thus, I cannot tighten it 
> and the housing turns. Does anyone have any thoughts about a solution 
> or any knowledge about purchasing the necessary parts?
>> 
>> Thanks very much.
>> 
>> Joe Aberdale
>> #908
>> 
>