[C320-list] Spade anchor

[jim brown]

________________________________
 From: jim brown <jbrown5093 at yahoo.com>
To: "C320-List at Catalina320.com" <C320-List at Catalina320.com> 
Sent: Tuesday, April 30, 2013 12:56 PM
Subject: Re: Spade anchor
 


Anyone know offhand if the 33 lb Spade Anchor will fit on the 320 roller and be self launching. I'm also concerned that the tip might be quite close to the hull when on the roller. I currently use a 22 lb Delta Fastset but was looking to add some weight and want to go to a spade design rather than a plow. 


Jim Brown
"Desafinado"



________________________________
 From: Don Dixon <donauw at bellsouth.net>
To: "C320-List at Catalina320.com" <C320-List at Catalina320.com> 
Sent: Tuesday, April 30, 2013 10:44 AM
Subject: Re: [C320-list] water heater
 

Remove the access panel on the front of the heater.  Under the panel is a red reset button for the high temp limit breaker.  Push to reset.

In my case, this did not work...needed to replace the heating element. 
 You can order an element specific for this unit or just buy a 1000 (or was it 1200?) watt unit at Home Depot for $9.95.  

Regards,

Don Dixon
Stargazer, #605
Key West, FL

Sent from my iPad

On Apr 30, 2013, at 9:19, wflowe3 at aim.com wrote:

> Did something stupid when opening up for spring (apparently spring is gonna last 3 days and then winter is coming back).  Filled all the water tanks, turned on the water heater (elec part) and waited for my hot water; it didn't come. After some mental trouble shooting, I remembered that I by-passed the water heater for winterization and I hadn't reconnected it.  So the heating element in the heater was heating air-not water. I don't think it liked heating air because once I plumbed the heater back in and it filled with water, still no hot water.
> 
> My question is  whether I
 burned out the element or is there some sort of tripping safety feature that needs to be reset?  The breaker on the panel did not trip.
> 
> Bill
> Hull # 1146
> (2008)