[C320-list] C320: Rudder stock head loose

[MSail]

Hi, Rick. Thanks.

Yes, you are correct there are two; I am using the one that enables the 
engine to go as far as possible to starboard.  I'll check the flange 
mounting to the engine and see if that can be moved.

Mike

----- Original Message ----- 
From: "Rick Sulewski" <rsulewski at bex.net>
To: <C320-List at Catalina320.com>
Sent: Tuesday, September 10, 2013 8:57 PM
Subject: Re: [C320-list] C320: Rudder stock head loose


Regarding the starboard motor mount, check to see if you have more than one
stud attachment point.  As I recall, there were two access holes on my
Westerbeke motor mounts/engine flanges where the studs are inserted and in
addition to that, the motor mounts may rotate slightly on the plates where
they are bolted to the floor pan.
Rick
1995 320 hull #277

-----Original Message-----
From: c320-list-bounces at lists.catalina320.com
[mailto:c320-list-bounces at lists.catalina320.com] On Behalf Of Sail email
Sent: Tuesday, September 10, 2013 10:54 PM
To: c320-list at lists.catalina320.com
Subject: [C320-list] C320: Rudder stock head loose

First,  I am seeing considerable vibration under power from play in the
"bearing" in the deck floor for the rudder stock.  There seems to be what I
would estimate to be 3-5 thousands play at least.

Has anyone else encountered this and is there a good fix available?

Secondly, has anyone experienced a situation where the front of the engine
(Westerbeke 30B) cannot go far enough to starboard to perfectly align the
shaft?  Any fix?

Third, have experiences with a Aquamet 19 or 22 SS prop shaft replacement
for the original bronze shaft been positive?  Any experience with shafts
from Deep Blue Yacht Supply?

Thanks.

Mike
Cat 320 #324