[C320-list] Water leak around sliding companionway hatch
tharrison at innovations-plus.com
tharrison at innovations-plus.com
Wed Jan 7 15:03:16 PST 2015
Look for a hair line crack in either the port or starboard side corners. Mine is on the port side.
I am going to take the cover off on the spring and put a "epoxy" in this crack.
Sent from my iPhone
> On Jan 7, 2015, at 3:17 PM, Chris Burti <clburti at gmail.com> wrote:
>
> The tape has nothing to do with the possibility of a leak. There are drain
> channels on either side of the hatch to divert water to the cockpit. The
> only way that i know of for water to get in where you are indicating is for
> it to be blown in, forced in under pressure as I sometimes do when washing
> the deck or if the aft end is stopped-up/blocked and it overflows.
>
>> On Wed, Jan 7, 2015 at 10:48 AM, Ade Bateman <lists at adrianba.net> wrote:
>>
>> Thanks Mike. I don't remember seeing any tape on the rails so perhaps mine
>> is gone too. Will head to the boat to take a look later. Is the tape thick?
>> I wonder if that would also reduce the vertical travel of the hatch which
>> seems to be able to move a fair amount.
>>
>> -----Original Message----- From: Michael Rauh
>> Sent: Tuesday, January 6, 2015 5:00 PM
>> To: C320-List at Catalina320.com
>> Subject: Re: [C320-list] Water leak around sliding companionway hatch
>>
>> I replaced the sliding hatch Teflon tape that is on top of both rails.
>> Mine had worn away.
>>
>> You can buy roll from Catalina Direct.
>>
>> Mike Rauh
>> On Your Mark #408
>>
>> Sent from my iPhone
>>
>>> On Jan 6, 2015, at 6:35 PM, Ade Bateman <lists at adrianba.net> wrote:
>>>
>>> Hi,
>>>
>>> I’ve been working through the various leaks (hull #257) including
>>> servicing the PSS and rebedding stanchions. It’s good to have a dry bilge
>>> but after the heavy rain in Seattle the past few days I discovered water
>>> leaking from the starboard side of the sliding hatch above the
>>> companionway. I’m not quite sure how water is getting in yet – I could see
>>> by pushing the hatch upwards that there was water between the plastic and
>>> the side rails that it sits on.
>>>
>>> It’s not a lot of water but I would like to prevent it getting in. Does
>>> anyone know how this is supposed to be sealed or have ideas where to start
>>> looking?
>>>
>>> Thanks.
>>>
>>> ----------------------------------
>>> _ _ | Ade Bateman
>>> / \-/ \ | Seattle, WA, USA
>>> \/)"(\/ | bateman at acm.org
>>> (_o_) | https://adebateman.org/
>>> | 425-614-9719
>>> ----------------------------------
>
>
> --
> Chris Burti
> Farmville, NC
More information about the C320-list
mailing list