[C320-list] Bleeding calorifier for cooling?

Onat Dogruer onat_s at yahoo.com
Mon Mar 20 09:24:09 PDT 2017


In addition to Warren's suggestion, similarly, I ran the engine with the cap off. Once the thermostat opens (when engine warms up to about 160), the antifreeze will start circulating in the engine and the water heater. This process will prevent any airlock; you can then top off if you need to.  Also, at a Yanmar course I took, the instructed recommended putting valves on the hoses going to the water heater so that one can isolate the loop if there is a problem. Hope this helps.

Can't wait to unshrink!Cheers,Onat 
#546, 1998


      From: Warren Updike <wupdike at hotmail.com>
 To: "C320-List at Catalina320.com" <C320-List at Catalina320.com> 
 Sent: Saturday, March 18, 2017 4:46 PM
 Subject: Re: [C320-list] Bleeding calorifier for cooling?
   
"calorifier" huh? Oh, you mean the water heater. I had to look that one up. 

It's possible to get an air lock in the hoses to the calorifier. You can tell because you won't have hot water after running the engine. There are a couple of techniques people use to clear the airlock. What I have done that seemed to work is to 1) remove the filler cap on the heat exchanger and if very full remove a small amount of antifreeze, 2)remove the highest hose to the calorifier at the engine, insert a funnel into the hose, hold funnel and hose as high above the engine as possible, and pour in antifreeze slooowly. This may force any air out of the hose and into the engine. You may even notice the level in the heat exchanger rise. Hope this helps. If not, try another technique.

Warren and Pattie Updike
1994 C320 "Warr de Mar" #62
Middle River, Chesapeake Bay

-----Original Message-----
From: Graeme Clark [mailto:cg at skyflyer.co.uk] 
Sent: Saturday, March 18, 2017 10:09 AM
To: Catalina list
Subject: [C320-list] Bleeding calorifier for cooling?

This will be first year I am attempting to re-commission and de-winterise my engine
I have fitted a new pump impeller and refitted the fan belts but was wondering whether there will potentially be an airlock in the heating system, especially the  loop that goes to the calorifier
There are a lot of valves and faucets on the calorifier which I have never previously touched!
Do I need to bleed anything and if so, how?
Thanks
Graeme
#366, 1996


Sent from mobile: please excuse typos etc.!




   


More information about the C320-list mailing list