[C320-list] KM2P SAE 30 OIL level

[CARY DENNIS LOWE]

Help

Sent from my iPad

> On Jun 4, 2019, at 6:31 PM, Michael Leschisin <mleschisin at imagestudios.com> wrote:
> 
> Hey Jeff,
> 
> I don’t have any concrete answers for you,  just my experience changing out my KMP2 oil this past fall.  
> 
> I used an oil extraction pump to suck out all the old oil and refilled with the 300ml the manual calls for.   That put me dead on the oil level line etched in the dip stick so I assume the line represents the proper oil level.  I can’t remember if I checked it immediately, but I do know that I finished up by idling the engine and shifting through gears then letting the oil settle for five or ten minutes before doing my final check. 
> 
> Hope this helps....
> 
> Michael Leschisin 
> #995
> 
>> On Jun 4, 2019, at 6:18 PM, Jeff Hare <Catalina at thehares.com> wrote:
>> 
>> Hi all, Hull 809 with 3gm30f yeu and Km2p transmission...I checked the transmission oil and saw that it was about 1/4" above the line.  Just setting the dipstick in, and a little higher when screwed in.  So I drained the transmission oil and put 300ml (0.3L) back in as the manual says for this km2p unit.  The oil level is now 1/2" higher than the old oil level.Is the line on the dipstick just the bare min oil level?    There is no upper oil level line...  I seem to have to ask this every time.  I have CRS apparently.Am I good here?Jeff Hare