[C320-list] Engine gauges

[David Prudden]

On a schematic of a 1999 320, it shows a “PUSH TO RESET” circuit breaker for the engine gauges. Does anyone know where this is?

Sent from my iPhone

> On May 28, 2019, at 2:15 AM, Graeme Clark <cg at skyflyer.co.uk> wrote:
> 
> Which in my boat is a pink wire with a thin black stripe on it, if that helps?
> It comes from the ignition switch not the terminal connector block
> Graeme
> 
> Sent from mobile: please excuse typos etc.!
> 
> 
>> On 28 May 2019, at 01:06, jackbrennan <jackbrennan at bellsouth.net> wrote:
>> 
>> There is a positive wire running from the ignition switch to the gauges. It obviously got disconnected in the shuffle.
>> Get your multimeter in there and trace the wires. It should be a simple fix.
>> Jack BrennanSonas, 1998 Catalina 320Tierra Verde, Fl.Dolphin Cruising Club of Tampa Bay
>> 
>> Sent from Yahoo Mail on Android 
>> 
>> On Mon, May 27, 2019 at 8:01 PM, David Prudden<dprudden at comcast.net> wrote:   Last fall, my starter button got stuck “in” , keeping the starter going. I was able to disengage the starter and replaced the starter button. Now, none of the engine gauges are doing anything. No tach, fuel, but most importantly, no engine temp (My water heater also got replaced so I’m not positive I have all the air out of the engine coolant looping through the water heater-i won’t know if there is an airlock and coolant isn’t flowing without the gauge. The engine is pumping raw water fine and she hasn’t run hot at all before, but i dont dare use her without knowing the status of the engine. I get launched in 12 days so I’m hoping someone has some ideas for me to check.
>> 
>> Thanks,
>> David Prudden
>> #787, Teachers Pet II
>> 
>> 
>> Sent from my iPad  
>