[C320-list] Leak appearing under holding tank

[Jamie Pett]

If you pumped the h. tank reasonably empty at 10, it can't be tank ? (My h. tank developed a hole several years ago and I had to replace it - the lower, forward, port corner had abraded against the hull due to small movement over years. (boat is 1999)  It was obviously the tank, as the holding tank contents are literally 'black water' and smell.  Cleaning and disinfecting the bilge was a task.  Fortunately for you, it doesn't sound like that to me.)

Given the 'path of water' you are seeing, I'd suspect something in the head under the sink - maybe the thru hull there (raw water intake, or sink drain).  Water under the head floor can path forward and appear to be coming under the holding tank.  

Jamie Pett
Bella Luna - #614
  


-----Original Message-----
From: C320-list [mailto:c320-list-bounces at lists.catalina320.com] On Behalf Of Joe Luciano
Sent: Tuesday, September 03, 2019 11:46 AM
To: C320-List at catalina320.com
Subject: Re: [C320-list] Leak appearing under holding tank

So can leaks from under the galley sink area.  The path a leak will take often times is indirect and can be a head scratcher.

Joe Luciano 
Second Wind 
2005 C-320

Sent from my iPhone

> On Sep 2, 2019, at 6:36 PM, Scott Thompson <surprise at thompson87.com> wrote:
> 
> Before taking out the holding tank I’d check the aft water tank and all thruhulls in the head compartment. Leaks from those areas can show up under the holding tank. 
> 
>> On Sep 2, 2019, at 9:25 PM, kskis at aol.com wrote:
>> 
>> Hello.  This morning after a 3:00AM trip to the head I began to hear the bilge pump turn on for 5 seconds every 15 minutes. Although I know the holding tank was not full I pumped out at 10:00AM.  The bilge pump continued its serenade every 15-25 minutes until I left the boat at 2:00PM today.  Fresh water pump never went on.  All areas leading to the bilge are dry except the area coming from directly under the holding tank.  There is a small puddle under the port/bow corner of the tank, just below the lower hose connection.  I can't reach my hand in to feel where the wet is coming from but I see a few very small drops of moisture on the plastic hose connection of that lower holding tank hose.  Most obvious is to check that hose connection which I can't reach to try to tighten.  All other areas are dry-macerator, hoses, etc.  Any other thoughts?  Does anyone know how that hose connection works?  Catalina Direct lists it as a "female" connection but not sure which direction to try to tighten it.  I ordered long-handled pump pliers but not even sure that will reach it.  Thinking I might have to start removing hoses and loosen the tank itself to even reach down there.  Any advice would be much appreciated.  Neil Kornblatt, #973 Harmony, East Hampton, NY
>> 
>> 
>> 
>> 
>> 
>> 
>