[C320-list] Sliding companionway hatch

[Jack Brennan]

Thanks, Troy. That-s a good recommendation. I think I will ask for a cut piece where ever I go because I don't trust myself on expensive detail work.

Jack Brennan



Sent via the Samsung Galaxy A32 5G, an AT&T 5G smartphone



-------- Original message --------
From: Troy Dunn via C320-list <c320-list at lists.catalina320.com>
Date: 10/22/24 7:16 PM (GMT-05:00)
To: C320-List at catalina320.com
Cc: Troy Dunn <troutwarrior at gmail.com>
Subject: Re: [C320-list] Sliding companionway hatch

Jack

If I were faced with this project I would order the cast acrylic from
estreet plastics.   Cut the acrylic on a table saw with a 50 tooth or
greater blade and then heat polish with a propane torch.

If any of those things are beyond skill level.   You can also ask them for
a quote to do the whole job.

Make sure you are ordering cast acrylic, thats what you want for hatches
etc.

https://www.estreetplastics.com/Gray-Smoked-Plexiglass-Acrylic-2064-1-2-p/x-t80500.htm


Regards
Troy Dunn
Hull #514