[C320-list] Engine noise

[Stanley Rogacevicz]

Kurt,
   I needed about 1.5 of the 1"  $50 pieces so had to buy 2. I probably
still have at least a couple square feet of it left after doing the
fridge wall. Hangers get complicated because the hangers they sell, and
I bought, were basically aluminum nails with very large tin washers
attached obviously for hanging the stuff from wood. I snipped off the
nails and used the washers replacing the nails with little nuts and
bolts going through the covers. I was paranoid about the stuff falling
off and getting down in the spinning shaft area in the rear or pulleys
up front. I believe others have 5200'd the stuff to the covers
sucessfully.
Stan

>>> krbmd77 at charter.net 12/01/05 9:21 AM >>>
Stan,

Thanks for the info re: soundproofing.  On the Defender website the kit
does not contain lead foil, but the one inch thick insulation by itself
does.  Therefore, can you please tell me how much insulation is needed
and what other supplies are necessary to hang it?
__
Kurt R. Budelmann, M.D.
Everwind, #1035
  ----- Original Message ----- 
  From: Stanley Rogacevicz 
  To: C320-List at catalina320.com 
  Sent: Thursday, December 01, 2005 8:48 AM
  Subject: RE: [C320-list] Engine noise


  Jon,
     Do it !! you'll be glad you did. I used the stuff from Defender
(as
  always cheaper than WM) 5 years ago that contains lead (I don't think
WM
  even had it) so my weight difference was significant but so was the
  difference in sound. I had forgotten how loud the standard 320 was
until
  went on a friends 98 a couple years ago - wow ! what a racket!! I
put
  off adding the external handles until last spring and it was a big
help
  for gripping the rear. I just used simple white cabinet door handles
  from a home goods type store for cheap.
  Stan
  (formerly) Christy Leigh
  c320 #656
  Wickford/Narragansett Bay RI

  >>> jonvez at comcast.net 12/01/05 7:45 AM >>>
  Dick,
  How much heavier does this make the two covers? I have been
  procrastinating on this project for a couple of off seasons now.
Perhaps
  it's good time to also add the external handle that some have added
to
  the aft cover....

  Regards,

  Jon Vez

  -------------- Original message -------------- 

  > What I have........ 
  > 
  > I just added the foam as noted below with the great help from
Stan's
  email 
  > and from the good hands on work of my CYC neighbor Ray Stone. The 
  > modification makes a large reduction to the sound, and probably
  contains 
  > heat. The job takes about 3 hours for some one not handy, me. 
  > 
  > I purchased 2 kits from West marine. 
  > Although it does not indicate on the box, my two kits of 1" came
  complete 
  > with Seam Tape and 10 Hangers each. All that was needed. The kits
  list for 
  > $89.99. I used 3M 5200 to secure the hangers although 2 part epoxy
  will 
  > also do the trick. The material has one side that has adhesive on
it.
  The 
  > kit instructions indicate that you should give it 2 minutes to get
  tacky 
  > before applying, do it quickly because it get tacky fast.. 
  > 
  > When you get the box open it and see if there is another box with
the
  items 
  > listed above, the label on the box did not indicate that it
included
  the 
  > extra parts and so does it not describe the parts being included
in
  the 
  > catalogue. 
  > 
  > I put the front cover on, turned the engine over a few times, with
  the red 
  > handle pulled up so it would not start, in order to see where I
had
  to pull 
  > away about 1/2 inch of material. I covered the space with the foil.

  > 
  > I used about 1 and 1/2 kits. I may cover the reefer side at a
later
  date. 
  > 
  > Cheers, 
  > 
  > Dick Walker 
  > 740 Olive Ave. 
  > Coronado, CA 92118-2136 
  > 619.435.8986 
  > -----Original Message----- 
  > From: C320-List-bounces at catalina320.com 
  > [mailto:C320-List-bounces at catalina320.com] On Behalf Of Jim
Harkness

  > Sent: Wednesday, November 30, 2005 11:24 AM 
  > To: C320-List at catalina320.com 
  > Subject: [C320-list] Engine noise 
  > 
  > OK - I know this is an old topic. 
  > 
  > Ours is a 1995 boat with the Westerbeke 30B engine installation
and
  its 
  > very noisy by todays standards. 
  > Remedies have been much discussed in the past with general
approval
  for 
  > increased insulation, I think. 
  > Can anyone tell me where to find the archived discussions
(pre-2005!)
  ot 
  > otherwise advise on experiences with extra insulation (eg problems
re

  > engine overheating, breathing) and/or how successful it was when
  finished? 
  > 
  > jim Harkness 
  > 
  > 
  > !!- _______________________________________ 
  > !!- C320-List at catalina320.com mailing list 
  > !!- Archives Here: http://www.catalina320.com/list/archives 
  > !!- Change Subscription Here:
http://www.catalina320.com/list/change 

  > !!- Subscribe Here: http://www.catalina320.com/list/join 
  > 
  > 
  > !!- _______________________________________ 
  > !!- C320-List at catalina320.com mailing list 
  > !!- Archives Here: http://www.catalina320.com/list/archives 
  > !!- Change Subscription Here:
http://www.catalina320.com/list/change 

  > !!- Subscribe Here: http://www.catalina320.com/list/join 
  !!- _______________________________________
  !!- C320-List at catalina320.com mailing list
  !!- Archives Here: http://www.catalina320.com/list/archives 
  !!- Change Subscription Here: http://www.catalina320.com/list/change

  !!- Subscribe Here: http://www.catalina320.com/list/join 

  !!- _______________________________________
  !!- C320-List at catalina320.com mailing list
  !!- Archives Here: http://www.catalina320.com/list/archives 
  !!- Change Subscription Here: http://www.catalina320.com/list/change

  !!- Subscribe Here: http://www.catalina320.com/list/join 
!!- _______________________________________
!!- C320-List at catalina320.com mailing list
!!- Archives Here: http://www.catalina320.com/list/archives 
!!- Change Subscription Here: http://www.catalina320.com/list/change 
!!- Subscribe Here: http://www.catalina320.com/list/join