[C320-list] Was leaving list, now zinc question for Orlando

[Orlando.Duran at AveryDennison.com]

I always used two sets of zincs..a clam shell type on the strut and the
shaft collar type..I believe if you look closely, there's a hole in the
strut for just this very application...

OD


                                                                          
             jonvez at comcast.n                                             
             et                                                           
             Sent by:                                                  To 
             c320-list-bounce         C320-List                           
             s at catalina320.or         <c320-list at catalina320.com>         
             g                                                         cc 
                                                                          
                                                                  Subject 
             12/14/2006 10:02         [C320-list] Was leaving list, now   
             AM                       zinc question for Orlando           
                                                                          
                                                                          
              Please respond                                              
                    to                                                    
                C320-List                                                 
             <c320-list at catal                                             
               ina320.org>                                                
                                                                          
                                                                          




Orlando,

You say you used a zinc on the strut of CL2? Just curious as to why since
it would be an isolated piece of metal? You have me concerned now since I
have never protected the struts on either my 30 or 320....

As for the other questions, our marina has no problem with divers and I
have the diver check and clean the bottom in the middle of the summer.
Never have had an issue with my shaft zinc--it's the prop zinc that I need
to watch.

I used 2 zincs for years, but my diver convinced me to try just one this
season and after about 7 months in the water, it proved to be just
right--just about half gone. I use Godfrey zincs which seem to work much
better than the Canada zincs you find in West.....

Regards,

Jon Vez

-------------- Original message --------------
From: Orlando.Duran at AveryDennison.com

> John,
>
> My dive service routinely replaces zincs as they are wearing out...here
in So
> Cal that would be every 4-5 months...on the 320 they would replace the
shaft and
> strut zincs and on the 440, I purchased 6 zincs from Flex-O-Fold that go
on the
> end of the prop that I will give to the diver so that it will be
installed as
> needed...
>
> Any reputable dive service should include zincs as part of their overall

> maintenance service for you...
>
> Have a great time on the 36! Is delivery eminent?
> ----------------------------------
> Regards,
> OD
>
> Sent from my BlackBerry Wireless Handheld
>
>
> ----- Original Message -----
> From: John Van Vessem [jvanvessem at sbcglobal.net]
> Sent: 12/10/2006 07:58 AM
> To: C320-List
> Subject: [C320-list] Leaving the 320 list
>
> To all my friends on the 320 list I just want to say what an educational

> pleasure it has been to read these conversations, I am moving to a 36
and hope
> to join their list if they have one. I'm going to miss my 320 it has
been an
> incredible boat and the whole reason I'm sticking with Catalina.
>
> Before I leave I need to tell you about a recent experience. My 320 was
> surveyed for the new owner and when we hauled it out of the water we
found that
> the bronze shaft had corroded down by about 1/8 inch in diameter, the
zinc was
> missing and was only 10 months old. Bottom line I had to spring for a
new
> shaft, stainless this time. Replacing the zincs has not been in my
standard
> maintenance routine. But after talking to the 320 dealer he suggested
that the
> zincs be replaced every couple of months. I'd like to hear what other
people
> have experienced who keep their boat in the water all year.
>
> John Van Vessem
> Sojourn 645
> Vallejo Yacht Club
>
>
> --------------------------------
> The information transmitted is intended only for the person or entity
> to which it is addressed and may contain confidential and/or
> privileged material. Any review, retransmission, dissemination or
> other use of, or taking of any action in reliance upon, this
> information by persons or entities other than the intended recipient
> is prohibited. If you received this in error, please contact the
> sender and delete the material from any computer.
>
>
>




--------------------------------
The information transmitted is intended only for the person or entity
to which it is addressed and may contain confidential and/or
privileged material. Any review, retransmission, dissemination or
other use of, or taking of any action in reliance upon, this
information by persons or entities other than the intended recipient
is prohibited. If you received this in error, please contact the
sender and delete the material from any computer.