[C320-list] attaching a Mast Cleat and a Spinnakker Pole Track

[Jeffrey Hare]

Yup.  Don't forget the TefGel on the bolt threads to prevent the corrosion..

Also (in case I haven't said this enough times already :)  don't forget to
unscrew each of the mast foot blocks and TefGel the Studs and threads.  A
friend had to unstep his mast and remove his mast step because some of them
seized up from the corrosion between SS to Aluminum.  Once every 4 or so
years is enough for that job.

-Jeff

-----Original Message-----
From: Steve Magennis [mailto:magenns at yahoo.com] 
Sent: Friday, July 14, 2006 7:14 PM
To: C320-List
Subject: Re: [C320-list] attaching a Mast Cleat and a Spinnakker Pole Track

I drilled and tapped the holes for the appropriate sized flat head
machine screw (as I recall, it was a 5/16" fine thread, 3/4"long
machine screw (NOT a sheet metal screw!!))

Steve
Alchemist #909

--- June Bruce <brucestanley36 at hotmail.com> wrote:

> attaching a Mast Cleat and a Spinnakker Pole Track
> Hopefully someone has done these, so my questions are:
> 
> 1) do I just drill and bolt it on?
> or
> 2) drill and CUT A THREAD, then bolt it on??
> 
> Appreciate all suggestions.
> 
> Bruce Stanley #1084
> 
> 
> 
> 


__________________________________________________
Do You Yahoo!?
Tired of spam?  Yahoo! Mail has the best spam protection around 
http://mail.yahoo.com