[C320-list] Ensign Staff Size

[alahlm at comcast.net]

quentin

       I fly my ensign and club burgee from the starboard  lower spreader on a halyard from the spreader to the inner genoa track

I also mounted my autohelm drive motor on the port side with no problems I believe the unit came with instructions for both locations

        Al Ahlman
           #476

-------------- Original message -------------- 
From: "Quentin Murphy" <qmurphy at sympatico.ca> 

> Dave: Thanks for the info on the flag staff holder size. What I would like 
> to know from those who store bilge-pump handles and fishing rods in the 
> holder: where do you fly your ensign? 
> 
> Quentin 
> Celtic Knot #667 
> 
> 
> -----Original Message----- 
> From: C320-List-bounces at catalina320.com 
> [mailto:C320-List-bounces at catalina320.com]On Behalf Of David Gleason 
> Sent: Thursday, March 23, 2006 12:03 AM 
> To: C320-List at catalina320.com 
> Subject: Re: [C320-list] Ensign Staff Size 
> 
> 
> Quentin: 
> 
> On Proud Mary, the bracket is the same 1" tube that the pushpit is made 
> from. Therefore, I had to cut down the staff to fit into the tube. I 
> believe it ended up some where around 3/4". I found that when it got 
> wet, it would swell up and was impossible to remove, so I had to sand it 
> down even more. 
> 
> Dave Gleason 
> Proud Mary, #150 
> 
> !!- Subscribe Here: http://www.catalina320.com/list/join 
> 
> 
> !!- _______________________________________ 
> !!- C320-List at catalina320.com mailing list 
> !!- Archives Here: http://www.catalina320.com/list/archives 
> !!- Change Subscription Here: http://www.catalina320.com/list/change 
> !!- Subscribe Here: http://www.catalina320.com/list/join