[C320-list] Water lines

Jeffrey Hare catalina at thehares.com
Sat Oct 28 07:35:10 PDT 2006


Hi Morey,

   It's the same fitting. They used to put a (grey?) cap over them.  Same
technique however.  Hold the end of the fitting and pull the pipe out.

The only thing holding it in is simply the o-ring seal around the outside of
the pipe.  It goes in and comes out hard by design...

-Jeff. 

-----Original Message-----
From: Morey Waltuck [mailto:mwaltuck at comcast.net] 
Sent: Saturday, October 28, 2006 10:13 AM
To: C320-List
Subject: Re: [C320-list] Water lines

Gentlemen,

Whale must have changed their systems because what I have is not what is
pictured in the Whale catalog or on the Catalina Photo Gallery.  But, it
seems to be what David described.  I do not have any (uncovered) collar that
can be pushed in.  I have seen that system.  What I have is a collar that
fits tightly to the main body that could possibly be pried away as David
describes, but I cannot verify that until tomorrow after our Nor'easter
leaves the Northeast.

I'll keep you "posted."

Morey Waltuck
Getaway #352


----- Original Message -----
From: <alahlm at comcast.net>
To: "C320-List" <c320-list at catalina320.com>
Sent: Saturday, October 28, 2006 9:12 AM
Subject: Re: [C320-list] Water lines


> Morey
> I don't think you need to remove the grey c clip --on mine you just push 
> the collar in and pull the 15mm pipe out --- the protective collar that 
> spins around does need to be slid back--see www.whale-usa.com
> -------------- Original message -------------- 
> From: David J Gleason <djgleason1 at juno.com>
>
>> Morey:
>>
>> To remove the line from a fitting it is very simple:
>>
>> 1 - Remove the plastic cap from the end of the fitting where the water
>> line enters. A small flat blade screwdriver works best.
>>
>> 2 - Remove the grey plastic C clip that is set into the fitting just
>> below where the line enters the fitting.
>>
>> 3 - Press down on the ring that the C clip was keeping in an extended
>> position.
>>
>> 4 - Pull the line out of the fitting.
>>
>> To reinstall, reverse the above steps.
>>
>> Dave Gleason
>> Proud Mary, #150
>>
>> On Fri, 27 Oct 2006 20:35:30 -0400 "Morey Waltuck"
>> writes:
>> > Our C320 was built in 1996 and has the Red and Blue piping system.
>> > To
>> > remove a water line from a fitting, do we somehow remove the end of
>> > the
>> > fitting which seems to rotate fairly freely?
>> >
>> > Morey Waltuck
>> > Getaway #352
>> >
>> >
>> >
>> >
>> >
>>
> 







More information about the C320-list mailing list