[C320-list] galley and head faucet

[Richard A. Walker]

I mentioned before that I removed the rubber pipe and hard plumbed the HOT
out to the whale fitting.  I understand that this is the way that new boats
are set up.

Cheers,
 
Dick Walker
C-320 (687) WindWalker II
740 Olive Ave.
Coronado, CA 92118-2136
619.435.8986


-----Original Message-----
From: c320-list-bounces at lists.catalina320.com
[mailto:c320-list-bounces at lists.catalina320.com] On Behalf Of Paul Rickman
Sent: Wednesday, April 15, 2009 3:34 PM
To: C320-List at Catalina320.com
Subject: Re: [C320-list] galley and head faucet

The only problem I am having is the hot side of the hot water heater.
Doesn't leak until it heats up.
Once while motoring I lost all my water. 

I put a new hose and clamp on it last year, this year it is leaking again.
Really frustrating.

Paul
Affinity 675




________________________________
From: Jack McDonough <mcdonough5 at verizon.net>
To: C320-List at Catalina320.com
Sent: Wednesday, April 15, 2009 5:45:52 PM
Subject: Re: [C320-list] galley and head faucet

I assume you mean the drip in the head is coming from the faucet. I haven't
had that problem but I've had trouble from time to time with the hard
plastic connector between the plastic tubing from the water tank and the
stem of the faucet under the sink. It has leaked quite a bit and there's no
intuitive way to figure out a solution. The local Catalina dealer even came
out to the mooring one day to try to resolve the problem. To make matters
worse, of course, it's impossible to get up under there with two hands
without completely removing the drawers in the aft cabin. I described this
problem here before but no one else apparently has had the same experience.

jack
#914





----- Original Message ----- From: "Robert Tiernay" <bob.tiernay at gmail.com>
To: <c320-list at lists.catalina320.com>
Sent: Wednesday, April 15, 2009 7:42 AM
Subject: [C320-list] galley and head faucet


> My head head faucet (with pull-out shower) has a bad drip.  I tried to
find
> the repair parts but I am not sure who the manufacturer is.  Scandvik says
> its not theirs. I might as well get parts for the galley faucet as well.
> Anybody have any idea on who the  manufacturer is?
> Bob Tiernay
> Windwalker hull 725
>