[C320-list] Overheating solution

[james_delong]

Gents,
Some weeks ago I posted a question on an overheating problem.  Many great comments were provided.

One, remove the hose at the heat exchanger to see if good water pressure existed there, proved to isolate the problem...it was before the exchanger.  So, although it looked good, I replaced the impeller.  Still little pressure, so we backed up and checked each component in the system. Hoses, strainer, then the seacock.

After removing the hose to the seacock and sticking a wire hanger down it, we had great flow.

The moral to the story is to start at the beginning, not somewhere in the middle!

Thanks to all for great suggestions!

Jim  #453