[C320-list] Overheating solution
Kirk McCullough
kirk.mccullough at telus.net
Sun Jan 11 11:58:54 PST 2009
Also if the wire coat hanger doesn't clear the seacock, try using your
inflatable dinghy air pump. It will blast out weeds etc easily. You can
connect it to the hose at the strainer and clear that entire section.
Kirk
#124
----- Original Message -----
From: "james_delong" <james_delong at bellsouth.net>
To: <c320-list at lists.catalina320.com>
Sent: Friday, January 09, 2009 5:53 PM
Subject: [C320-list] Overheating solution
Gents,
Some weeks ago I posted a question on an overheating problem. Many great
comments were provided.
One, remove the hose at the heat exchanger to see if good water pressure
existed there, proved to isolate the problem...it was before the exchanger.
So, although it looked good, I replaced the impeller. Still little
pressure, so we backed up and checked each component in the system. Hoses,
strainer, then the seacock.
After removing the hose to the seacock and sticking a wire hanger down it,
we had great flow.
The moral to the story is to start at the beginning, not somewhere in the
middle!
Thanks to all for great suggestions!
Jim #453
More information about the C320-list
mailing list