[C320-list] Edson /// X-5 installation

[Rick Sulewski]

Jack, 

You should have no problem with the X-5 wheel drive unit mounting on the
helm wheel. The X-5 drive is the same as the (grey) S-1 drive unit that
replaced the older (black) ST 4000 drive unit.....I replaced all of the
instruments on my boat over the summer. 

If I am not mistaken the installer had to mount the X-5 computer on the
stern bulk head and that required an additional wire run to the pedestal to
tape into the control head. The wheel drive latch/lever to lock the drive
unit in the auto mode had to be cut at an angle to clear the pedestal engine
control panel. Depending on your engine instrument panel, you may be able to
lower the instrument panel to provide the clearance for the wheel drive
locking lever.

Rick
My-Ria #277

-----Original Message-----
From: c320-list-bounces at lists.catalina320.com
[mailto:c320-list-bounces at lists.catalina320.com] On Behalf Of
BAdams3491 at aol.com
Sent: Saturday, November 21, 2009 2:00 PM
To: C320-List at Catalina320.com
Subject: Re: [C320-list] Edson

You might check out the web site  www.edsonmarine.com  If  no luck there, 
call them.
 
Bert
At Ease
#442
 
 
In a message dated 11/21/2009 12:34:11 P.M. Central Standard Time,  
chuters at earthlink.net writes:

I'm  installing a Raymarine X5 Wheel Pilot wheel drive unit on our 97 C320
and  wanted to know the spoke mm diameter size of the 6 spoke Edson  40"
Destroyer.  Any info would be helpful.

Thanks in  advance

Jack
s/v Wetted  Bliss
#441