[C320-list] routing of electrical from panel to bildge

[Chris Burti]

The bottom and side panels of the box are removable and doing so makes
fishing wires much easier...

It is extremely important to remember  to disconnect your batteries at the
lugs (battery selector switch is/should be bypassed to power your bilge
pump) and to shut off the master AC power breaker in the aft locker before
doing this unless you like fireworks in close proximity to your fingers and
that wonderful acid taste on your tongue that an electrical shock
stimulates..

On Sun, Feb 7, 2010 at 11:57 PM, Pat Ireland <cherie320 at gmail.com> wrote:

> All
>
> Need clarification on how to route electrical wiring from bildge to the
> distribution panel.  It looks like there is a path through the Port Settee,
> but I,m not finding a way to feed wiring through the area below the
> distribution panel.  Does the bottom of the box remove, do you need to cut
> an access hole, or is it just a fish tape exercise from the settee to the
> distribution box?
> Your guidence is greatly appreciated.
>
> Pat, 801
>



-- 
Chris Burti Farmville, NC