[C320-list] Packing change

[Paul Rickman]

You take the length of packing and wrap it around the shaft and
the cut it straight with a razor knife. When done you should have
three pieces cut exactly the length you need.


Paul
Affinity 657
Bay Bridge Marina
Chesapeake Bay Maryland 



________________________________
From: "cdescher at cedtulsa.com" <cdescher at cedtulsa.com>
To: C320 List <C320-List at Catalina320.com>
Sent: Sat, April 2, 2011 6:09:40 PM
Subject: Re: [C320-list] Packing change

How do you know the lengths needed for the replacement pieces?  Problem is, my 
bilge pump is dead.    By the way west marine is out of those.  I am trying to 
keep tomorrow me from being mad at today me. 

Sent via BlackBerry by AT&T

-----Original Message-----
From: Amshd2 <amshd2 at aol.com>
Sender: c320-list-bounces at lists.catalina320.com
Date: Sat, 02 Apr 2011 16:56:30 
To: <C320-List at Catalina320.com>
Reply-To: C320-List at Catalina320.com
Subject: Re: [C320-list] Packing change


I have done this a couple of times and for me it is hard to say maybe a couple 
of gallons at that most...much  depends on how long it takes you to get the old 
stuff out.  I wrap the leaking side with a an old rag to slow things down ...and 
have my shop vac ready  to catch some of the water as well.......

Key is to have everything ready to go....  have the new pieces measured and cut 
and all the tools laid out as well..

Tony 










-----Original Message-----
From: cdescher at cedtulsa.com
To: C320 List <C320-List at Catalina320.com>
Sent: Sat, Apr 2, 2011 3:36 pm
Subject: [C320-list] Packing change


Can anyone tell me approximately how much water comes in when you change the 
acking material?
Thanks for any help.  
ent via BlackBerry by AT&T