[C320-list] microwave openning
wflowe3 at aim.com
wflowe3 at aim.com
Fri Feb 4 06:10:59 PST 2011
Thanks Barb and Bruce. I contemplated trying to route out the trim piece because there is plenty of room for a larger oven inside the cabinet. I couldn't find a way to remove the trim and I'm not a good enough carpenter to try and route it out while it is in place.
-----Original Message-----
From: Barbara Uhlman <uhlman at sbcglobal.net>
To: C320-List <C320-List at Catalina320.com>
Sent: Thu, Feb 3, 2011 8:25 pm
Subject: Re: [C320-list] microwave openning
So far, I have found one set of notes. It says that the micro is
h 9 5/8
w 19 1/2
d 11 1/2
The cabinet is (these make no sense!!)
h 10 1/2 (something about a 5/8" lip, probably what hangs down from above.)
w 15 1/2 11 1/4
d (5 3/4) 17 1/2
The micro that came on the boat is http://www.sailorsams.com/mall/tm5030.asp as
a point of comparison
We went to the boat last Sat. but probably won't again for some time. If I find
any more notes, will let you know.
Barb
________________________________
From: "wflowe3 at aim.com" <wflowe3 at aim.com>
To: C320-List at Catalina320.com
Sent: Thu, February 3, 2011 2:29:06 PM
Subject: Re: [C320-list] microwave openning
Me too but I can't find my notes either. The Microwave I found at Walmart is 9
7/8" hi. I was thinking the opening is 10". It is only $45 so I thought I would
get a couple as stand bys if they fit.
-----Original Message-----
From: Barbara Uhlman <uhlman at sbcglobal.net>
To: C320-List <C320-List at Catalina320.com>
Sent: Thu, Feb 3, 2011 1:33 pm
Subject: Re: [C320-list] microwave openning
The micro is probably 1/4" too tall. I will try to find our measurements.
We've certainly measured enough times!!
________________________________
From: "wflowe3 at aim.com" <wflowe3 at aim.com>
To: c320-list at lists.catalina320.com
Sent: Thu, February 3, 2011 1:16:57 PM
Subject: [C320-list] microwave openning
Does anyone have the height measurement for the opening of the microwave
compartment on 2006-2009 boats? The (Tappan) Microwaves supplied with the boats
are not very reliable and have been discontinued. I think I found GE one that
will fit but I can't get to the boat to measure.
More information about the C320-list
mailing list