[C320-list] Tool program

[pat reynolds]

Herb,  I have done this with three stanchions.  I removed the wood strip and 
then made a 2.5 inch hole in the liner underneath.  This sends a lot of 
fiberglass dust so were goggles, mask and gloves to avoid irritation.  The wood 
strip covers the holes.  I may have fat fingers so I don't know how people 
remove the large nut and two smaller ones without making a hole.  since there 
are several stanchions which may need work in the future, I think it would be 
more practical to just buy a hole saw to have on hand instead of paying postage 
both ways each time.



----- Original Message ----
From: Allan S. Field <allan.field at verizon.net>
To: C320-List at Catalina320.com
Sent: Sat, May 14, 2011 9:33:06 AM
Subject: Re: [C320-list] Tool program

Herb - The hole saw I have cuts a 2.5-inch hole.  My memory however is that
I thought about using a Dremel to cut away the fiberglass panel in order to
get to the nuts behind.  Either that or an angled ratchet?  I have a Dremel,
it is not part of the toolbox program, but would be glad to lend it to you
if you think that would do the trick.  But first, I would suggest asking the
list for ideas of how to access these nuts; I have never done so. - Allan
FIELD

-----Original Message-----
From: c320-list-bounces at lists.catalina320.com
[mailto:c320-list-bounces at lists.catalina320.com] On Behalf Of
hcreech at comcast.net
Sent: Saturday, May 14, 2011 8:50 AM
To: C320-List
Subject: [C320-list] Tool program

I need to obtain a hole saw from the tool program. I need the one that will
allow me to address a stanchion leak above the aft stateroom. If Allan
Fields could contact me directly at hcreech at comcast.net I would be
appreciable. 

Thanks, 
Herb Creech 
Cloud Chaser 606