[C320-list] Wire Access behind chart table

[Jeff Hare]

You may also find that a piece of wire when fed down through one of the holes on the right hand side of the panel bottom will just magically appear in the port-aft most settee. I've done that several times and it never took more than a couple tries.

Jeff

Allan S Field <allan.field at verizon.net> wrote:

You don't need to remove the chart table to make that wire run. My
recommendation is to go to Home Depot or Lowes and look for a fiberglass
stick that is about 5 foot long, very flexible and very thin that is used
to run a messenger line. They have a cap with a small hole on either end
for tying the messenger to. These things are much easier to use and less of
a hassle than the reel-type wire snakes. Push the stick down through the
hole that the bundle goes through and it will come out in the port settee,
aft corner. This is the chase I used to run my tank monitors.

Allan S. Field
Sea Shadow - #808
Columbia, MD

-----Original Message-----
From: c320-list-bounces at lists.catalina320.com
[mailto:c320-list-bounces at lists.catalina320.com] On Behalf Of John Meyers
Sent: Saturday, August 18, 2012 9:22 PM
To: C320-List at catalina320.com
Subject: [C320-list] Wire Access behind chart table

I need to run a power wire from the breakers to the port settee. There is a
group of wires that descend out of the breaker box area to behind the chart
table. If I remove the chart table will I be able to push/pull a set of
wires down and then into the settee? Or is there another route those wires
can take?

Thanks in advanced. This group has taught me a lot of useful things that I
really needed to know.

John Meyers
#406 1977
Wind Chime
Muskegon MI