[C320-list] new salt water in bilge

[hcreech at comcast.net]

Nat, 
Not only does it have to be supported, unless you are incredibly strong it will take two people to torque the bar to the proper setting. Years ago I did mine on land and was not able to reach the recommended torque. 

Herb Creech 
Cloud Chaser 606 



----- Original Message -----
From: "Nat Antler" <nantler at pacbell.net> 
To: c320-list at lists.catalina320.com 
Sent: Sunday, July 8, 2012 1:26:11 AM 
Subject: [C320-list] new salt water in bilge 

After a few years with our 1994 #161 which has always had a dry bilge, we discovered accumulation of salt water... about 1/8" -1/4" in the aft section an about the same in the main section with the main keel bolts. I have ordered the torque wrench from the member site with the hope that they may need tightening. Can they be tightened while the boat is in the water or do I need to haul out and support the keel to tighten them? Is this something that others have experienced? I'm concerned why it just started showing up after 2-3 years. 

BTW my previous question about that "froggy" noise was solved by watering the house battery cells... several were very low. Thanks!