[C320-list] Main Halyard wear

[Mike Paris]

I contacted Garhauer today and they said that it is likely a worn tooth or it may be from slight slippage causing excessive wear. I will be able to check this weekend. I will be buying a new halyard and still am undecided on what to replace it with and wear to order it from. I do like the idea of cutting a foot off each year to extend wear.

Mike P
#734


On Jun 1, 2012, at 1:43 PM, Warren Updike <wupdike at hotmail.com> wrote:

> A simple thing is to cut about a foot off of your halyards every few years so the points of wear on the lines are changed.  Just be sure you're cutting from the working end.  This should prevent the kind of abuse you are seeing.  Running rigging should be sized liberally enough to that a foot every few years shouldn't matter.
> 
> -----Original Message-----
> From: fred.lecuyer at live.com [mailto:fred.lecuyer at live.com] 
> Sent: Friday, June 01, 2012 11:49 AM
> To: C320-List at Catalina320.com
> Subject: Re: [C320-list] Main Halyard wear
> 
> Mike,
> 
> I'm also replacing none for the same reason. I look forward to hearing a solution.
> 
> Fred
> 
> Sent from my HTC Inspire™ 4G on AT&T
> 
> ----- Reply message -----
> From: "Mike Paris" <mparis495 at gmail.com>
> To: "C320-List at Catalina320.com" <C320-List at Catalina320.com>
> Subject: [C320-list] Main Halyard wear
> Date: Fri, Jun 1, 2012 10:32 am
> 
> 
> I replaced my Main halyard 3 years ago with 3/8" Sta-set. It is very worn in the area where it is in the clutch when raised.It's to the point where it looks like it could break at any time.  Is this a normal rate of wear? I'm going to replace it, any suggestions? Also, can the clutches be adjusted?
> 
> Thanks,
> Mike P
> #734
> 
> 
>