[C320-list] 1998 Chainplate rust

[Chris Burti]

Deck core rot is NOT an issue with factory installed hardware on a
C-320. Decks are solid glass at the chainplates, winches, turning
blocks, stanchions, etc.

Regards,
Chris Burti
Commitment, Hull #867


On Fri, Mar 30, 2012 at 9:01 PM, Dick Walker <dickwalker at att.net> wrote:
> We have a year 2000 boat.  It can be rust the chain played are SS.  EASY TO ROMOVE POLISH AMN REBED
>
> Cheers
>
> Dick Walker
> 740 Olive Ave.
> Coronado, CA
> 619.435.8986
>
> On Mar 30, 2012, at 17:41, Pat Ireland <cherie320 at gmail.com> wrote:
>
>> If you are seriously interested in a 320, spend some time reading the old
>> posts and the 320 international site.  There is a lot of this type of info
>> that has been posted over time.  I do not remember anyone commenting on
>> rusted chainplates, but there is an article on bedding chain plates that
>> would help you understand what is involved.
>>
>> Faults - Microwaves are difficult to replace.  Some repair and others
>> modify the cabinet.  Battery charger is suspect and usually replaced.
>> Roller furler often needs rebuild due to no flush holes.  Upgrade parts are
>> reported available.  Head odors are reported if waste is allowed to sit in
>> hoses.  Fix is to replace with high end hose and use fresh water for
>> flushing.  Original toilets likely need to be replaced.  A new jabsco on
>> sale is recommended by some while a Raritan upgrade might be appropriate if
>> you plan to keep the boat over 5 years.   Engine raw water pumps are a bit
>> pricy but can be repaired if you are handy.  Most pop for a new one and go
>> sailing.  The Wheel chain and cable assembly should be checked.  They are
>> not fragile, but do need to be replaced as they wear.  The Autopilots seem
>> to need replacement as will other electronics that are over 14 years of
>> age,
>>
>> But the worst fault is you will not want to get rid of it if you do buy it.
>>
>> On Fri, Mar 30, 2012 at 2:43 PM, Onat Dogruer <onat_s at yahoo.com> wrote:
>>
>>> Hello all,
>>>
>>> We are looking into 320 as our next boat. One we saw and happen to like in
>>> all other factors, has rust at chainplates inside the cabin. The deck core
>>> around it doesn't seem to be damaged though. They clearly need to be
>>> rebedded. It is a 1998. Have any other 1998 owners out there noticed a
>>> similar known issue with chainplates? Also any other known issues we should
>>> be aware off? Just trying to gather as much information as possible. Much
>>> appreciated.
>>>
>>> Onat
>>>
>>>



-- 
Chris Burti
Farmville, NC