[C320-list] 1998 Chainplate rust

[Chris Burti]

Also solid aluminum plate is laminated in for winches, traveller, rope
clutches, etc. which were tapped and threaded for the bolts...so no
leak issues at those points either.

On Sat, Mar 31, 2012 at 8:12 AM, Chris Burti <clburti at gmail.com> wrote:
> Deck core rot is NOT an issue with factory installed hardware on a
> C-320. Decks are solid glass at the chainplates, winches, turning
> blocks, stanchions, etc.
>
> Regards,
> Chris Burti
> Commitment, Hull #867
>
>
> On Fri, Mar 30, 2012 at 9:01 PM, Dick Walker <dickwalker at att.net> wrote:
>> We have a year 2000 boat.  It can be rust the chain played are SS.  EASY TO ROMOVE POLISH AMN REBED
>>
>> Cheers
>>
>> Dick Walker
>> 740 Olive Ave.
>> Coronado, CA
>> 619.435.8986 begin_of_the_skype_highlighting              619.435.8986      end_of_the_skype_highlighting
>>
>> On Mar 30, 2012, at 17:41, Pat Ireland <cherie320 at gmail.com> wrote:
>>
>>> If you are seriously interested in a 320, spend some time reading the old
>>> posts and the 320 international site.  There is a lot of this type of info
>>> that has been posted over time.  I do not remember anyone commenting on
>>> rusted chainplates, but there is an article on bedding chain plates that
>>> would help you understand what is involved.
>>>
>>> Faults - Microwaves are difficult to replace.  Some repair and others
>>> modify the cabinet.  Battery charger is suspect and usually replaced.
>>> Roller furler often needs rebuild due to no flush holes.  Upgrade parts are
>>> reported available.  Head odors are reported if waste is allowed to sit in
>>> hoses.  Fix is to replace with high end hose and use fresh water for
>>> flushing.  Original toilets likely need to be replaced.  A new jabsco on
>>> sale is recommended by some while a Raritan upgrade might be appropriate if
>>> you plan to keep the boat over 5 years.   Engine raw water pumps are a bit
>>> pricy but can be repaired if you are handy.  Most pop for a new one and go
>>> sailing.  The Wheel chain and cable assembly should be checked.  They are
>>> not fragile, but do need to be replaced as they wear.  The Autopilots seem
>>> to need replacement as will other electronics that are over 14 years of
>>> age,
>>>
>>> But the worst fault is you will not want to get rid of it if you do buy it.
>>>
>>> On Fri, Mar 30, 2012 at 2:43 PM, Onat Dogruer <onat_s at yahoo.com> wrote:
>>>
>>>> Hello all,
>>>>
>>>> We are looking into 320 as our next boat. One we saw and happen to like in
>>>> all other factors, has rust at chainplates inside the cabin. The deck core
>>>> around it doesn't seem to be damaged though. They clearly need to be
>>>> rebedded. It is a 1998. Have any other 1998 owners out there noticed a
>>>> similar known issue with chainplates? Also any other known issues we should
>>>> be aware off? Just trying to gather as much information as possible. Much
>>>> appreciated.
>>>>
>>>> Onat
>>>>
>>>>
>
>
>
> --
> Chris Burti
> Farmville, NC



-- 
Chris Burti
Farmville, NC