[C320-list] Wiring Diagram

[Colin Evans]

Thanks Don,
It is a very similar diagram and legible 
*************************
Regards
Colin Evans
Watermark 
Hull 774 
Lake Macquarie, Australia
 

-----Original Message-----
From: c320-list-bounces at lists.catalina320.com
[mailto:c320-list-bounces at lists.catalina320.com] On Behalf Of Donald Lawson
Sent: Wednesday, 14 November 2012 12:07 PM
To: C320-List at Catalina320.com
Subject: Re: [C320-list] Wiring Diagram

Colin
Try this link. Found it on the Cat 30 website.  Didn't read it but it may be
good info anyway.  http://www.catalina30.com/techlib/Wiring Diagrams
Boat/Seaward Upgrade Info.pdf   Whale pumps aquired Seaward in October. 
Don Lawson
#1005

On Nov 13, 2012, at 2:54 PM, Colin Evans wrote:

> Bruce,
> Thanks for your comments.  We have a new starter and the problem
continues.
> The starter button sticks and I can hear the additional rattle of the
> starter gear.  The flywheel doesn`t throw it out.
> I may just replace the push button as I`m having a bit of a problem
getting
> a waterproof switch.  (I`m about to try motorcyle suppliers.) 
> 
> 
> ************************************
> Regards
> Colin Evans
> __/)
> ~~~~~
> 
> 
> -----Original Message-----
> From: c320-list-bounces at lists.catalina320.com
> [mailto:c320-list-bounces at lists.catalina320.com] On Behalf Of Bruce Heyman
> Sent: Wednesday, 14 November 2012 8:38 AM
> To: C320-List at Catalina320.com
> Subject: Re: [C320-list] Wiring Diagram
> 
> Colin,
> Sorry to hear about the death of your starter.  Our year 2000 has a three
> position ignition switch.  The third position does not do anything except
> psych me out.  The starter switch should be a simple normally open single
> pole single throw switch.  
> 
> Once the engine starts running the RPMs should be high enough to disengage
> the starter's gear from the flywheel.  If that didn't happen then it
sounds
> like you may have had something also wrong with the starter.
> 
> Bruce
> Somerset 2000 currently San Diego
> 
> Bruce Heyman
> 949 289-8400
> 
> Colin Evans <twosailors at bigpond.com> wrote:
> 
>> We have just had a problem where the engine starter button didn`t
release,
>> causing the starter motor to be driven by the flywheel at a more than
>> healthy speed, and burning out. It didn`t take long.
>> My intention is to replace the ignition switch with a 3 position keyed
>> switch and get rid of the push button starter.
>> Does anyone know of a legible wiring diagram for the starter switch,
water
>> temp, fuel gauge etc.  The one available in the manual is almost
impossible
>> to read.
>> *************************
>> Regards
>> Colin Evans
>> Watermark #774
>> Lake Macquarie, Australia
>