[C320-list] Freedom 10 inverter/charger

[Gene Helfman]

After a winter of shameful neglect in which all three old batteries
completely discharged (two 4Ds and a smaller backup) and died and were
replaced (kaching), we now find we're getting no output from our 15 yr old
 Freedom 10 inverter/charger. This means that batteries are not being
charged when on shore power and there's no electricity from the AC outlets
when we're just running on batteries.  We have current flow to the
inverter/charger and its fuse is not blown.  We have turned the inverter on
and off and pushed the two reset breaker buttons on the top to no avail.
 Are there resets we are missing, do we need to play with dip switches,
etc?  Should we go through the steps in the manual for initial
installation?  Or is the unit toast? Does anyone have experience with this?


Gene Helfman
*Satori*, #398 1997

-- 
Gene Helfman, Professor Emeritus
Odum School of Ecology, University of Georgia
PERMANENT address:
    498 Shoreland Dr., Lopez Is., WA 98261
    (360) 468-2136
    genehelfman at gmail.com

"You noticed nobody gives a damn about beached minnows."