[C320-list] Engine (not) starting

[clburti at gmail.com]

I don’t think so. You don't say, but did you test by jumping the leads on the key switch?



Fair Winds
Chris Burti
Commitment
Catalina 320, #867



From: david.allred at verizon.net
Sent: ‎Friday‎, ‎August‎ ‎16‎, ‎2013 ‎4‎:‎35‎ ‎PM
To: C320-List at Catalina320.com

   I think I found the inline harness fuse, fairly easily accessible from
   the front of the engine on the port side.  It is a small, two-pronged
   fuse that plugs into a black holder.  Unfortunately for me, that fuse
   (I think a 1 amp) was fine as was a similar 10 amp fuse in the same
   kind of holder located close to the first one (it was fine, too).  I
   did not see any other fuses near the engine.  Could there be another
   one somewhere between the pod and the one I found?  At any rate, I will
   continue to pursue the problem rather than abandon my boat because I
   can't start the engine.
   DLA


   On 08/16/13, clburti at gmail.com wrote:

   That inline harness fuse is on the port side of the engine.
   Fair Winds
   Chris Burti
   Commitment
   Catalina 320, #867
   From: Irving Grunes
   Sent: �Friday�, �August� �16�, �2013 �3�:�39� �AM
   To: [1]C320-List at catalina320.com
   I think there is an inline fuse in the wiring harness in the cableing
   going
   to the pod.
   Also check the connections at the terminal block of that cabeling in
   the pod
   irv grunes
   2001 #851
   On Fri, Aug 16, 2013 at 1:49 AM, [2]fred.lecuyer at live.com <
   [3]fred.lecuyer at live.com> wrote:
   > I think there is a fuse in the pod where you were. Check inside the
   pod.
   >
   > Fred
   > #960
   >
   > Sent from my HTC Inspire� 4G on AT&T
   >
   > ----- Reply message -----
   > From: [4]david.allred at verizon.net
   > To: <[5]C320-List at Catalina320.com>
   > Subject: [C320-list] Engine (not) starting
   > Date: Thu, Aug 15, 2013 7:34 pm
   >
   >
   > My boat is #712 , a 2000 model. The engine is a Yanmar 3GM30F.
   > DLA
   >
   >
   > On 08/15/13, Williamyahoo.com> wrote:
   >
   > What make on engine do you have ? What year is your boat?
   > Mike Ott
   > Sent from my iPhone
   > On Aug 15, 2013, at 6:56 PM, [1][6]david.allred at verizon.net wrote:
   > > Today I replaced my temp gauge. The engine cranked as usual, but
   the
   > > gauge did not appear to work. I took the face off the backing and
   > > fiddled with the gauge connections. When I attempted to start the
   > > engine again, it would not start--nothing at all when I pressed the
   > > start button and I noticed that all the gauges were dead with the
   key
   > > on. Apparently, there is no electricity going to the control panel.
   I
   > > depressed the 10 amp breaker switch at the bottom of the panel, but
   > > still nothing. The batteries are good and the RayMarine instruments
   > as
   > > well as everything in the cabin are working. Can you suggest what I
   > > may do? Is there another fuse/relay breaker somewhere? Thanks.
   > > DLA
   >
   > References
   >
   > 1. [7]mailto:david.allred at verizon.net
   >
   >

References

   1. mailto:C320-List at catalina320.com
   2. mailto:fred.lecuyer at live.com
   3. mailto:fred.lecuyer at live.com
   4. mailto:david.allred at verizon.net
   5. mailto:C320-List at Catalina320.com
   6. mailto:david.allred at verizon.net
   7. mailto:david.allred at verizon.net