[C320-list] winches

[Bruce Heyman]

Art,
I have never removed the turning blocks but they are normally backed by aluminum plates that are between the layers.  They are then drilled and tapped to accept the winch screws.
Bruce

Bruce Heyman
(949) 289-8400

Arthur Miller <millers1 at aol.com> wrote:

>Does anyone know how the primary winch turning blocks are fastened to the deck???
>Opening the Stbd. locker shows no through bolts.  How are the hold down screws securred?
>Also, has anyone added a 2nd set of winches nearer  the helm?  Any installation comments 
>Welcome.  
>Art. #680
>-----Original Message-----
>From: jim brown <jbrown5093 at yahoo.com>
>To: C320-List <C320-List at Catalina320.com>
>Sent: Tue, May 7, 2013 5:24 pm
>Subject: Re: [C320-list] [C320-lBilge Pump 37202 PDF
>
> I think the list strips attachments-most list serves do that. 
>
>Jim Brown
>
>
>
>
>________________________________
> From: Karl Mielenhausen <kmielen at suddenlink.net>
>To: C320-List at catalina320.com 
>Sent: Tuesday, May 7, 2013 3:29 PM
>Subject: Re: [C320-list] [C320-lBilge Pump 37202 PDF
> 
>
>OK.
>It's a pdf titled "37202" and should be attached.
>
>Karl
>
>On Tue, May 7, 2013 at 2:14 PM, Irving Grunes <igrunes at gmail.com> wrote:
>
>> Karl
>> Couldn't find the enclosure
>> Irv
>>
>> On Tue, May 7, 2013 at 1:06 PM, Karl Mielenhausen <kmielen at suddenlink.net
>> >wrote:
>>
>> > Here you go.
>> > I had the boat for years before I realized that the connecting rod should
>> > be lubricated annually.
>> > And don't get me going about how easy it is for stuff from that locker to
>> > jam the exposed mechanism!!
>> >
>> > Karl
>> >
>> > On Tue, May 7, 2013 at 11:09 AM, Irving Grunes <igrunes at gmail.com>
>> wrote:
>> >
>> > > Karl
>> > > Can you please resend that PDF re the bilge pump parts list.
>> > > Our pump failed by the motor seizing up because the eccentric that
>> > attaches
>> > > the diaphragm arm to the motor shaft also failed
>> > >
>> > > Also note that our boat has the 37202-0000 that has a metal three hole
>> > > mount base plate.
>> > >
>> > > The current WM replacement is a 37202-2012 that has a plastic four hole
>> > > base plate.
>> > >
>> > > Thanks
>> > > Irv Grunes
>> > > 2001 #851
>> > >
>> >
>>