[C320-list] Rudder Problem

[Millers]

Joe,  with the guidance provided by mike crawl into aft steering and inspect while an other person turns the wheel. I suspect a dry rudder shaft.   May need to be greased.  Art

Sent from my iPhone

On May 8, 2013, at 6:42 PM, Joseph R Aberdale <summerwind3 at comcast.net> wrote:

> Mike,
> 
> The rudder still turns when turning the wheel. Would it be possible to still work if there is a slipped steering cable off one of the pulley's?
> 
> Thank you Mike.
> 
> On May 8, 2013, at 6:11 PM, William Ott <wmo48 at yahoo.com> wrote:
> 
>> Joe,
>> Have you inspected the rudder quadrant cabling and pulled the inspection cover from the overhead in the aft cabin?  You could have slipped a steering cable off one of the idler pulleys.
>> Mike Ott
>> 'Amanda Lu'
>> #508 
>> 
>> Sent from my iPad
>> 
>> On May 8, 2013, at 5:53 PM, Joseph R Aberdale <summerwind3 at comcast.net> wrote:
>> 
>>> My boat is on the hard ready to launch next week. When turning the wheeI I found that there is a rumbling noise with considerable vibration in the wheel and pedestal holding the electronics. This condition was not there at all when hauling the boat out last fall. I appreciate any thoughts you might have regarding the cause of this.  
>>> 
>>> Thank you.
>>> 
>>> Joe Aberdale
>>> #908
>