[C320-list] Rudder Problem

[Joseph R Aberdale]

Where do you apply the grease? Any particular type of grease?

Thanks Art.

On May 8, 2013, at 6:50 PM, Millers <millers1 at aol.com> wrote:

> Joe,  with the guidance provided by mike crawl into aft steering and inspect while an other person turns the wheel. I suspect a dry rudder shaft.   May need to be greased.  Art
> 
> Sent from my iPhone
> 
> On May 8, 2013, at 6:42 PM, Joseph R Aberdale <summerwind3 at comcast.net> wrote:
> 
>> Mike,
>> 
>> The rudder still turns when turning the wheel. Would it be possible to still work if there is a slipped steering cable off one of the pulley's?
>> 
>> Thank you Mike.
>> 
>> On May 8, 2013, at 6:11 PM, William Ott <wmo48 at yahoo.com> wrote:
>> 
>>> Joe,
>>> Have you inspected the rudder quadrant cabling and pulled the inspection cover from the overhead in the aft cabin?  You could have slipped a steering cable off one of the idler pulleys.
>>> Mike Ott
>>> 'Amanda Lu'
>>> #508 
>>> 
>>> Sent from my iPad
>>> 
>>> On May 8, 2013, at 5:53 PM, Joseph R Aberdale <summerwind3 at comcast.net> wrote:
>>> 
>>>> My boat is on the hard ready to launch next week. When turning the wheeI I found that there is a rumbling noise with considerable vibration in the wheel and pedestal holding the electronics. This condition was not there at all when hauling the boat out last fall. I appreciate any thoughts you might have regarding the cause of this.  
>>>> 
>>>> Thank you.
>>>> 
>>>> Joe Aberdale
>>>> #908
>>