[C320-list] Edson Tiller Arm Connection Detail for Linear Drive, Size of Blocks Limiting the Rudder Movement

[Dave and Ev]

I noticed on the photos on the Catalina 320 website that the linear 
drive is connected to the tiller arm on top of the tiller arm instead of 
inside the tiller arm per the Edson detail. What is the distance from 
either the centerline of the rudder post or from the edge of the rudder 
post to the center of the pin/bolt? Is it located in the third or fourth 
indentation on the Edson tiller arm from the rudder post?
Also what is the size of the blocks that were installed to limit the 
movement of the rudder? I see in the Raymarine instructions if the unit 
is not properly protected by limiting the range of motion that the 
warranty can be void.
Any comments and suggestions are sincerely appreciated.
Dave Cushman
It Tips