[C320-list] Genoa turning blocks

[Denny Browne]

That's how I did it too. New ones from Garhauer are great. 

Denny Browne
310.408.9591

Sent from iPhone, sorry for typos, grammar, etc...

> On Jun 9, 2014, at 2:31 AM, Bruce Heyman <bruceheyman at cox.net> wrote:
> 
> Hi Pat,
> Yes they do come off.  After removing the four screws I then used a really thin paint scrapper to break the seal.  I used a rubber mallet to force the scrapper into the bedding compound and was careful to not damage the fiber glass.  Then used goo-be-gone to clean up the surface.
> Good luck,
> Bruce
> 
> Bruce Heyman (949) 289-8400
> 
> pat reynolds <lorasalum at yahoo.com> wrote:
> 
>> need to replace genoa turning block.  I have removed the 4 screws but can't budge the block.  tried tapping it with hammer.  Has anyone removed/replaced these.  I am thinking maybe they are bedded with 3M 5200 caulk.  If so has anyone any experience removing this sealant?