[C320-list] Re varnishing the sole

[danb70341 at gmail.com]

Rod
Yes. I will call catalina for some stain advise. Thanks

Sent from my iPad

> On May 15, 2015, at 9:06 AM, "Rod Boer" <rod.boer1 at verizon.net> wrote:
> 
> I don't believe that there was any stain used on my sole, just varnish. Did
> the bleach spill on one of the dark strips or across both the dark and light
> strips?
> 
> Rod
> 
> -----Original Message-----
> From: C320-list [mailto:c320-list-bounces at lists.catalina320.com] On Behalf
> Of danb70341 at gmail.com
> Sent: Thursday, May 14, 2015 11:12 AM
> To: C320-List at Catalina320.com
> Subject: Re: [C320-list] Re varnishing the sole
> 
> I am also interested in redoing sole so thanks for insights. In my case
> previous owner spilled some bleach on the sole and I have to find a matching
> stain. Do you know what stain to use? Thanks
> 
> Sent from my iPad
> 
>> On May 13, 2015, at 7:26 PM, "Rod Boer" <rod.boer1 at verizon.net> wrote:
>> 
>> Hi Jim,
>> 
>> Actually, I don't remember but I am visiting the boat tomorrow for some
> maintenance chores and I will check it out and get back to you. I should
> also mention that I had an error in my email where I stated that there
> wasn't anywhere where the finish wasn't worn through. I meant to say that
> there was no place that was worn through.  It is much easier to refinish
> when the original finish is intact.
>> 
>> Rod
>> 
>> -----Original Message-----
>> From: C320-list [mailto:c320-list-bounces at lists.catalina320.com] On Behalf
> Of jim brown
>> Sent: Wednesday, May 13, 2015 11:19 AM
>> To: C320-List at Catalina320.com
>> Subject: Re: [C320-list] Re varnishing the sole
>> 
>> Rod, 
>> 
>> Just curious since I haven's removed the sole under the dining table. How
> is the table fastened to (or through since the sole in pretty thin) to the
> sole. 
>> 
>> Jim BrownDesafinado 973
>> 
>>     From: Rod Boer <rod.boer1 at verizon.net>
>> To: C320-List at Catalina320.com
>> Sent: Tuesday, May 12, 2015 7:37 PM
>> Subject: Re: [C320-list] Re varnishing the sole
>> 
>> Hi Chris,
>> 
>> I refinished mine in 2007.  I should note that there wasn't anywhere that
> the finish wasn't worn through.  I used the material that I think was
> originally used and that was "TARGET WB2025 Interior Matte Waterborne
> Urethane Wood Finish".  I don't know whether this is still available or a
> replacement made for it, but I think I have enough left from the quart to do
> it again.  I removed my floor and took it home over winter.  I used a very
> fine sand paper to slightly abrade/scuff it and then I applied the finish
> with a relatively expensive brush which I think made the job come out
> especially nice.  The brush was maybe 3-4" wide but very thin like maybe
> 1/4" or less.  I put two coats on it and the results were very good.
>> 
>> There was a sole finishing article in the Mainsheet that another member,
> Warren Updike, contributed and may be on the web site.  The sole to his boat
> had considerably more wear than mine.  His approach was somewhat different.
>> Check the C320 website for the article.  If it isn't there and you are in
> the same situation with a "well worn" sole, then let me know and I might be
> able to provide the article.
>> 
>> Rod Boer, Odyssey, #688
>> 
>> 
>> 
>> -----Original Message-----
>> From: C320-list [mailto:c320-list-bounces at lists.catalina320.com] On Behalf
> Of Chris Nichols
>> Sent: Tuesday, May 12, 2015 6:01 PM
>> To: C320-List at catalina320.com
>> Subject: [C320-list] Re varnishing the sole
>> 
>> Hi
>> Does anyone have experience with this job and care to share any advice?
>> Should we attempt to do it in-situ or is there a good reason to/not-to
> strip out the boards and do them in the shop at home?
>> What varnish did you use and has it worn well?
>> Many thanks in advance
>> 
>> Chris Nichols
>> AmandaRose #476
>> 
>> Sent from my iPhone
>