[C320-list] temp gague

[Brian Carol Mclamb]

Hi Jim.  Found this only in the junk mail of my e-mail today.  Brian

Sent from my iPad

> On Mar 24, 2016, at 12:57 PM, jim brown <jbrown5093 at yahoo.com> wrote:
> 
> Sorry to add on to an existing thread but I suspect my initial email went into spam files again (not sure why but it's happened before) So I'll try this route. On first start up of the season I notice the temp gauge read over 180 with a cold engine (Yanmar 3gm) Shut down engine and with key off temp gauge was at baseline Turned key on and again over 180. Engine temp was room temp with an infrared thermometer. Took off wires to temp sensor in the out line to the water heater and gauge remained at base line even with key on. Any ideas and is there a troubleshooting procedure for the temp gauge on the website like there is for the fuel gauge?
> Jim Brown   
> 
>      From: Graeme Clark <cg at skyflyer.co.uk>
> To: C320-List at Catalina320.com 
> Sent: Thursday, March 24, 2016 12:35 PM
> Subject: Re: [C320-list] Anyone replaced their cabin sole?
> 
> Jeff
> 
> I cant tell you for sure but murphy’s law says that you will need a certain whole number plus one fiftieth of an  8X4 sheet!
> 
> 
> Graeme
> 
>> On 24 Mar 2016, at 16:21, Jeff Hare <catalina at thehares.com> wrote:
>> 
>> Just curious, if anyone on this list has replaced the cabin sole in a 320.
>> 
>> 
>> 
>> If so, how much material did you have to buy?
>> 
>> 
>> 
>> -Jeff Hare
> 
> ———————————————————
> I work irregular hours and often write emails late in the evening and at weekends; that doesn’t mean I expect you to do the same; reply when convenient!
> 
> 
> 
> 
> 
> 
>