[C320-list] Locked out of the head?

Gene Helfman genehelfman at gmail.com
Mon May 8 14:42:03 PDT 2017


Been there, done that.  Only about 5 minutes of real panic before calming
down enough to come up with the same solution.

But here's a new one we discovered yesterday.  If after you pump out the
holding tank (legally of course) and "someone" forgets to close the outflow
valve, external water pressure is sufficient to eventually fill the holding
tank up from the outside until the toilet overflows. I would have thought
there was a check valve that didn't permit that but found out I was wrong.

Satori, #498, 1997

On Mon, May 8, 2017 at 2:29 PM, Graeme Clark <cg at skyflyer.co.uk> wrote:

> I was idly lubricating the small lock on the inside of the heads which had
> pretty much jammed up over the years with corrosion and slammed the door
> shut from the outside with the catch in the locked position - doh!
>
> The hatch was shut so no way to access the inside
>
> Fortunately I had refinished the door varnish over winter and had noticed
> when I removed the lock to do that, that it works by preventing the square
> bar  that connects the two handles from turning rather than acting on the
> door catch itself
>
> So if you ever do this, the trick is to remove the outer door handle
> (Allen key grub screw) and push the bar right thru the lock until it and
> the inner handle drop on the floor of the head. You can then turn the lock
> mechanism using a suitable sized screwdriver in the square hole!
>
> Phew!!!
>
> Graeme
> #366, 1996
>
> Sent from mobile: please excuse typos etc.!
>
>
>


-- 
Gene Helfman, Professor Emeritus
Odum School of Ecology, University of Georgia
PERMANENT address:
    498 Shoreland Dr., Lopez Is., WA 98261
    (360) 468-2136
    genehelfman at gmail.com

*I'm a mad scientist.  And I'm growing madder with each passing day.*


More information about the C320-list mailing list