[C320-list] Leaking Opening Port

[Elizabeth Schwartz]

ahoy all.....The only leak I have on #245....'95.....is on one of the 
opening portlights in the salon.....leaks between the plastic lens and 
the gasket......would that be just the gasket to replace for 
fix?....Thanks...Joe 


On Thu, Oct 05, 2017 at 12:09 PM, Ade Bateman wrote:

>> On Thu, Oct 05, 2017 at 05:31:15, Rick Sulewski wrote:
>>
>>   FYI - something to consider when replacing port lights :
>>
>> Last year I discovered a way to easily remove/release each frame from
>> the hull in less than 20 seconds each without damage and without 
>> prying
>> off the frame from the exterior side (after removing all of the 
>> inside
>> frame retaining screws).
>> I simply leaned against the frame from the inside with a screw driver
>> placed first in the  middle of each side for about 3-5 seconds and 
>> then
>> in the middle of the lower frame section for a few seconds before I
>> could simply push the frame off the hull. Used "Goof Off" to easily
>> remove the old sealant from the hull in about 3 minutes for each port
>> after briefly scrapping off a small amount of old excess sealant left
>> after the frame released.  Most of the time was spent liberally 
>> prepping
>> the new frames with Bed It butyl rubber sealant. Installed each port
>> from the inside to place it against the exterior side of the hull 
>> from
>> the inside without the need for an extra pair of hands. Drew the 
>> frames
>> tighter with the interior frame ring over several minutes to squeeze 
>> out
>> the excess sealant that was easily removed from the exterior of the 
>> hull
>> a few days later with a razor blade.
>
> While I've used Bed It butyl tape for resealing lots of things, I 
> actually
> used Life Calk for re-bedding my leaking portlights (and installing a
> new replacement). I've found it more difficult to get a consistent 
> seal
> with the tape on larger areas where you need to bend and potentially 
> layer
> the tape. Plus you really need to tighten hardware incrementally to 
> let the
> butyl find it's way into all the gaps. I preferred a more liquid 
> sealant
> for doing the portlights.
>
> Ade.
>